DIY Touchless Doorbell for Your Smart Home

Introduction ===============

Are you tired of the hassle of traditional doorbells that require you to physically press a button to ring the doorbell? Do you want to upgrade your smart home with a touchless doorbell that provides a more modern and convenient experience? Look no further! In this blog post, we will guide you on how to create a DIY touchless doorbell for your smart home.

Read more

Materials Needed =====================

To create a DIY touchless doorbell, you will need the following materials:

• A Raspberry Pi or a small single-board computer
• A PIR (Passive Infrared) sensor
• A relay module
• A doorbell chime or a speaker
• A power supply for the Raspberry Pi
• A USB cable
• A microSD card
• A case or enclosure for the Raspberry Pi

Read more

Step-by-Step Instructions ============================

Step 1: Set up the Raspberry Pi

First, you need to set up the Raspberry Pi. Insert the microSD card into the Raspberry Pi and connect the power supply. Connect the USB cable to the Raspberry Pi and your computer. Open a terminal or command prompt and navigate to the directory where you have extracted the Raspberry Pi's operating system.

Step 2: Install the necessary software

Install the necessary software for the PIR sensor and the relay module. You can use the following commands:

• `sudo apt-get install python-pir`
• `sudo apt-get install python-relay`

Step 3: Connect the PIR sensor and the relay module

Connect the PIR sensor to the Raspberry Pi's GPIO pins. Connect the relay module to the Raspberry Pi's GPIO pins as well.

Step 4: Write the Python script

Write a Python script that will read the PIR sensor and trigger the relay module when motion is detected. You can use the following code as a starting point:

``` import RPi.GPIO as GPIO import time

GPIO.setmode(GPIO.BCM)

pir_pin = 17 relay_pin = 23

GPIO.setup(pir_pin, GPIO.IN) GPIO.setup(relay_pin, GPIO.OUT)

while True: if GPIO.input(pir_pin): GPIO.output(relay_pin, GPIO.HIGH) time.sleep(1) GPIO.output(relay_pin, GPIO.LOW) time.sleep(0.5) ```

Step 5: Test the DIY touchless doorbell

Test the DIY touchless doorbell by moving in front of the PIR sensor. The relay module should trigger the doorbell chime or speaker when motion is detected.

Read more

Conclusion =============

With these simple steps, you can create a DIY touchless doorbell for your smart home. This project is a great way to upgrade your home's security and convenience while also saving money by not having to purchase a commercial touchless doorbell. With a little creativity and some basic electronics knowledge, you can create a unique and functional touchless doorbell for your home.

Read more